BOMBARDIER Sonic Betreibershandbuch PDF herunterladen (Seite 23)

Drive Belt Removal

+

WARNING:

Never start or run

the engine without the drive belt

installed. Running an unloaded engine

is dangerous.

1. Tilt the hood and remove the pulley

guard.

2. Open the driven pulley by twisting

and pushing the sliding half. Hold in

fully open position.

3. Slip the belt over the top edge of the

sliding half.

4. Slip the belt

out

from the drive pul-

ley and remove completely form the

vehicle. To install the drive belt,

reverse the procedure.

Drive Belt Condition

Inspect belt for cracks, fraying or ab-

normal wear (uneven wear, wear on

one side, missing cogs, cracked fabric).

If abnormal wear is noted, probable

cause could be pulley misalignment, ex-

cessive R.P.M.

with

froozen track, fast

starts

without

warm-up period, burred

or rusty sheave, oil on belt or distorted

spare belt. Contact your dealer.

Check the drive belt

width.

If less than

2.7 cm

(11/16

in), replace the drive belt.

New

drive belt

When installing a new drive belt, break-

in period of 25 km (15 miles) is strongly

recommended.

O

NOTE: Always store a spare belt

in a manner to allow its natural

shape to be maintained.

Brake condition

The brake mechanism on your snow-

mobile is an essential safety device.

Keep this mechanism in proper

work-

ing condition. Above all, do

not

oper-

ate your snowmobile

without

an effec-

tive brake system.

THE

MINIMUM

BRAKE PAD THICK-

NESS IS

3 mm (1/8 in).

+

W ARNING: Brake pad or pucks

lessthan 3 mm

(118

in.) thick must

be replaced. Replacement must be per-

formed by an authorized dealer.

21

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare