BOMBARDIER Sonic Betreibershandbuch PDF herunterladen (Seite 29)

"Adjusting screws

Headlamp Beam Adjustment

To adjust, on vehicles so equipped, re-

move the headlamp ring, turn the up-

per or lower adjusting screws

obtain

the desired beam position.

Headlamp Bulb Replacement

If the headlamp is burnt, tilt hood and

unplug the connector from the head-

lamp. Remove the rubber boot and

un-

fasten the bulb retainer clips. Detach

the bulb and replace.

Taillight Bulb Replacement

If the taillight bulb is burnt, expose the

bulb by removing the red plastic lens.

(Two

(2) Phillips head screws) .

...

WARNING: Always check light

......

after bulb replacement.

General Inspection

Check electrical wiring and compo-

nents, retighten loose connections.

Check for stripped wires or damaged

insulation. Thoroughly inspect the

ve-

hicle and tighten loose bolts, nuts and

linkage. Inspect skis and ski runners for

wear.

Intensity zone

of high beam

(projected on

the

walll

Headlamp

horizontal

center line

With the suspension correctly ad-

justed, the rider seated on the vehicle

and the high beam

ON (engine must be

running on manual start models),

check that the center of the high inten-

sity zone of the high beam

is 50 mm

(2")

below the horizontal nne of the

headlamp height.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

BOMBARDIER Sonic Betreibershandbuch Seite 29

Kommentare zu diesen Handbüchern