
Brake Adjustment
Brake should apply fully while brake
control lever is still 2.5 cm
(1
inch) MIN
1-
MUM
from the handlebar grip.
2.5 em (1 inl MINIMUM
If a minor adjustment is indicated,
slack
off
the cable housing nut (A) and
tighten the nut (B) to increase the lever
clearance.
Once minor adjustment is completed,
firmly tighten the nuts (A and B)
against the bracket. If correct brake
control lever clearance is unobtainable,
proceed
with
major adjustment as fol-
lows:
Slacken
off
the nut (c) retaining the
brake cable to the lower brake lever.
Adjust the cable to required length by
lenthening or shortening the brake
cable. Retighten the nut. Ensure that
minor adjustment nuts are located
ap-
proximately half way on the adjuster
threads.
22
•
WARNING:
Brake cable must
make a loop around the bolt head.
Strongly pull the brake handle to check
cable tightness.
•
WARNING:
Always check the
brake light to see if it functions
af-
ter performing btake adjustment.
Brake Light
Adjustment
The brake light is blocked
with
two
lock
nuts.
If brake light does not function:
Loosen lock nut
(0).
Move the switch
forward on its bracket and tighten lock
nut (E).
If brake light stays on:
Loosen lock nut (E). Move back the
switch on its bracket and tighten lock
nut
(0).
_ CAUTION: The brake switch body
...
is made of plastic material. Only
tighten lock nuts until switch has no
free play.
Kommentare zu diesen Handbüchern